Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools

* EN 45059 - Angle Meter

* EN 48034 - Crankshaft Balancer Installer

* EN-50792 - Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools Special Tools.




1. To prevent crankshaft rotation, install EN-50792 - flywheel holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flywheel.




2. Using EN-48034 - installer, install the crankshaft balancer (2).

Caution: Refer to Fastener Caution Fastener Caution.

Caution: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

3. Install a NEW crankshaft balancer bolt and washer. Tighten the bolt to 150 Nm (111 lb ft) plus 180 degrees using the EN 45059 - meter.

4. Remove EN-50792 - flywheel holding tool.