Rear Parking Assist Alarm Sensor Replacement

Rear Parking Assist Alarm Sensor Replacement

Removal Procedure





1. Disconnect electrical from the rear object sensor.

Note:
The rear object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.

2. Lift the locking tabs on the housing and remove the rear object sensor.

Installation Procedure

Note:
Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.

1. Paint the rear object sensor.

2. Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals.





Note:
Ensure the silicone decoupling ring is installed on the sensor to avoid sensor failure.

3. Insert the sensor into the housing.

4. Connect the electrical connector to the rear object sensor.