Allison - Automatic Transmission

DTC P0602

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0602

-
Transmission Control Module (TCM) Not Programmed

Circuit/System Description

The transmission control module (TCM) determines if it has a proper calibration. The TCM detects the presence of improper calibration by checksum and name comparison. This is internal to the TCM. No external circuits are involved.

Conditions for Running the DTC

The TCM conducts the test one time at power up.

Conditions for Setting the DTC

The DTC will set if the default calibration is detected.

Action Taken When the DTC Sets

The transmission will go to a hydraulic default shift mode of reverse, neutral and third range.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics Electrical Diagrams

Connector End View Reference

* Component Connector End Views 1-2 Shift Solenoid (SS) Valve (M30)

* Inline Harness Connector End Views X100

Description and Operation

* Transmission General Description Transmission General Description

* Transmission Component and System Description Transmission Component and System Description

* Electronic Component Description Electronic Component Description

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Ignition on, verify that DTC P0602 does not set.

Circuit/System Testing

1. Re-calibrate the TCM. Refer to Control Module References Control Module References for TCM replacement, setup, and programming.

2. Ignition on, verify that DTC P0602 does not set.

• If DTC resets, replace the TCM. Refer to Control Module References Control Module References for TCM replacement, setup, and programming.

3. Perform fast learn procedure. Refer to FastLearn Procedure Programming and Relearning.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Control Module References Control Module References for TCM replacement, setup, and programming.

* FastLearn Procedure Programming and Relearning

Repair Verification

If another DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle and perform the appropriate diagnostic procedure.