Seat - Will Not Tilt Forward
90chevy27Number: 90-339-10
Section: 10
Date: August 1990
Corp Bulletin No.:061011R
Subject: INERTIA LOCK ON BENCH-BUCKET SEATS/ SEAT WILL NOT TILT FORWARD
Model and Year: 1988-90 CK TRUCKS
TO: ALL CHEVROLET DEALERS
Some owners of 1988 - 1990 C/K trucks except A50/AE7 seats in 1988-1990 extended cab models and A52 seats in 1990 regular cab models may be expressing concern that their seat will not tilt forward without using the latch release mechanism. This condition has been determined to be a result of a bind in the seat back inertia locking mechanism. This bind is a result of a foam buildup causing the pendulum mechanism to lock. Use of the latch release mechanism will overcome any interference caused by the foam. Hence the seat back can still be tilted forward.
SERVICE PROCEDURE:
The following steps should be followed to correct the inertia lock bin
Figure No. 1:
1) Remove seat back to expose the hinge assembly shown in Figure 1.
2) If equipped remove the inertia lock cover assembly (added in 1989).
Figure No. 2:
3) Locate inertia lock pendulum as shown in Figure 2. You will notice foam trapped below, behind and on top of the pendulum.
4) Clear away any trapped foam and confirm that the inertia mechanism swings freely.
Figure No. 3:
5) As shown in Figure 3, pull back cloth or vinyl covering and cut away about 3/4 of an inch of foam from near the hinge assembly.
6) Reinstall inertia lock cover (if equipped) to hinge assembly.
7) Clear away any excess foam that may be laying loose to ensure that no foam remains to get caught in the pendulum again.
8) Place cloth cover back over the foam.
9) Reattach seat back.
WARRANTY INFORMATION
For vehicle repaired under warranty use:
Labor Operation: T7021
Labor Time: .4 hr.
FAILURE CODE: 92
NOTE: Labor Operation is coded to base vehicle coverage in the warranty system.