Cam Unit Assembly
INSTALL OR CONNECT
1. Cam plate to the side cam gear.
2. Wave washer.
3. Clutch plates.
- Alternate the plates and position the wave washer as shown.
4. Thrust sleeve.
- Press the thrust sleeve flush with the side gear disc spline.
5. Guide clips to the plates.
- Use a chassis grease in the clips to hold them in place on the plates.
A. If the side gear or thrust sleeve has been replaced, measure and record the overall length of the gear to the back of the thrust sleeve including the side gear thrust washer.
B. Compare this reading with the reading obtained earlier.
C. If the new reading is more than 0.0762 mm (0.003 inch) higher or lower than the original, select a side gear thrust washer that will return the reading closest to the original reading.