Internal Components

1. Remove oil pump attaching bolts and washers.

2. Using pump remover tool No. J 24773-A remove pump assembly.

3. Remove oil pump seal and gasket.

4. Remove inside detent lever retaining bolt and the inside detent lever.

5. Remove detent lever and actuator.

6. Remove parking lock bracket retaining bolts and the bracket.

7. Remove parking pawl return spring and shaft retainer.

8. Remove parking pawl lock shaft and shaft plug.

9. Remove forward clutch assembly with turbine shaft.

10. Remove direct clutch assembly with front band assembly.

11. Remove intermediate clutch assembly snap ring.

12. Remove intermediate clutch backing plate.

13. Remove clutch plates, and waved plate if used.

14. Remove case to center support attaching bolt.

15. Remove snap ring.

17. Remove center support and gear unit assembly using gear assembly remover tool No. J-21 795-02, adaptor tool No. J 21364-A and holding fixture tool No. J-6116-01.


18. Remove the sun gear shaft.

19. Remove rear band, thrust washer and selective thrust washer.