Install

1. Install eight check balls as shown in the figure.

2. Install gasket spacer plate to case.

3. Install complete valve body assembly onto case using guide pin set tool No. J-25025-S or equivalent

4. Install pressure manifold onto valve body assembly with spring and roller assembly in place.

5. Install wiring clip, then the fluid indicator stop.

6. Install control valve body assembly retaining bolts.

7. Connect wiring harness to connectors. Install large end into case first.

8. Install long end of lube pipe into case.

9. Install lube pipe clip with short bolt, tighten to specification.

10. Tighten valve body bolts to specification.

11. Install filter,-then the pan and refill fluid.