Assembly

^ Tools Required:
- J 36609 Bearing Installer
- J 36600 Seal Installer

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Bearing. Use J 36609. Drive into place with a hammer.





2. Seal. Use J 36600.
3. Shaft with deflector to the axle tube.
4. Washer. Align the tabs with the slots in the tube.
5. Gear with retaining ring. Drive gear into place with a plastic hammer.