Less Hydraulic Clutch System

1. Disconnect battery ground cable, then remove coffer pin and washers from clutch pedal rod.

2. Remove clutch start switch, noting position for installation reference, then the nut, bolt and washers from clutch pivot arm.

3. Remove clutch pivot arm, pedal rod and bushing. Release retracting spring by depressing pedal, moving pedal laterally and releasing.

4. Remove pedal and bushings, then the bumper, if worn or damaged.

5. Reverse procedure to install. Adjust clutch linkage as described under "Clutch, Adjust." Refer to Clutch/Adjust