Without A/C

Heater Control Assembly:

REMOVE OR DISCONNECT

1. Screws (64).

2. Control assembly (63).

3. Electrical connectors, as necessary.

4. Vacuum connectors, as necessary.

5. Temperature cable.

6. Blower switch, if necessary.

- Remove the blower switch knob and spring clip, and remove the blower switch.


Inspect

- Electrical terminals for corrosion. Remove the corrosion or replace the component as necessary.

- Temperature and mode levers for freedom of movement. Lubricate, repair, or replace as necessary.

- Temperature control cable for kinks, binding, and other damage. Repair or replace as necessary.


INSTALL OR CONNECT


1. Heater blower switch, if removed.

- Hold the blower switch in position and install the spring clip.

- Install the blower switch knob.


2. Temperature cable.

3. Vacuum connectors, as necessary.

4. Electrical connectors, as necessary.

5. Control assembly (63).


NOTICE: Refer to "Fasteners" under "Vehicle Damage Warnings."


6. Screws (64).

- Tighten screws (64) to 1.6 Nm (14 lbs. in.).

7. Check circuit operation.