C0221

DTC C0221 RF Wheel Speed Sensor Open:

DTC C0221 RF Wheel Speed Sensor Circuit Open 1 Of 2:

DTC C0221 RF Wheel Speed Sensor Open 2 Of 2:

CIRCUIT DESCRIPTION
The wheel speed sensor coil emits an electromagnetic field. A toothed ring on the wheel passes by the wheel speed sensor and disrupts this electromagnetic field. The disruption in the field causes the wheel speed sensor to produce a sinusoidal (AC) voltage signal. The frequency and amplitude of the sinusoidal (AC) voltage signal are proportional to the speed of the wheel. The amplitude of the wheel speed signal is also directly related to the distance between the wheel speed sensor coil and the toothed ring. This distance is referred to as the air gap.

CONDITIONS FOR SETTING THE DTC
- No output signal from the right front wheel speed sensor for 1.0 second.
- Excessive right front wheel speed sensor resistance for 1.0 second.

ACTION TAKEN WHEN THE DTC SETS
- The ABS indicator lamp turns on
- The ABS disables

DTC C0221 is a Condition Latched DTC, which indicates that the above actions remain true only as long as the condition persists.

CONDITIONS FOR CLEARING THE DTC
- Repair the conditions responsible for setting the DTC
- Use the Scan Tool Clear DTCs function

DIAGNOSTIC AIDS
Any of the following conditions may cause an intermittent malfunction:
- A poor connection
- Wire insulation that is rubbed through
- A wire breaks inside the insulation

Thoroughly check any circuitry that is suspected of causing the intermittent complaint for the following conditions:
- Backed out terminals
- Improper mating
- Broken locks.
- Improperly formed or damaged terminals
- Poor terminal to wiring connections
- Physical damage to the wiring harness

If the customer says that the ABS indicator lamp is on only during humid conditions such as rain, snow, or vehicle wash, then thoroughly inspect all wheel speed sensor circuits for signs of water intrusion.

Use the following procedure:
1. Spray the suspected area with a 5% salt water solution (two teaspoons of salt to 12 oz. of water)
2. Drive the vehicle above 24 km/h (15 mph) for at least 30 seconds

If the DTC returns, replace the suspected harness.

When inspecting a wheel speed sensor, inspect the sensor terminals and the harness connector for corrosion. If evidence of corrosion exists, then replace the wheel speed sensor.

WSS Temperature Vs. Sensor Resistance (2WD Only):

DTC C0221 RF Wheel Speed Sensor Circuit Open:

Resistance of the wheel speed sensor will increase with an increase in sensor temperature. Refer to the tables for temperature/resistance values.

TEST DESCRIPTION
The numbers below refer to the steps in the diagnostic table:
2. This step checks the resistance of the right front wheel speed sensor circuit.
3. This step checks for continuity in the right front wheel speed sensor harness.
4. This step checks the resistance of the right front wheel speed sensor.