Front Door: Adjustments

Perform this procedure only when bolt-on replacement hinges are installed.

TOOLS REQUIRED
J 29843-9 TORX(R) Bit (Bit Size T47)




1. Using the J 29843-9 or a similar tool, remove the door striker bolt.
2. Loosen the door hinge to the body side pillar bolts.




3. Adjust the door at the door hinges in the following directions:
^ Upward or downward
^ Forward or rearward
^ Inward or outward
4. Adjust the gap between the rocker panel and the door to 4.0-8.0 mm (0.16-0.31 in).
5. Adjust the gap between the door and the roof panel to 3.0-9.0 mm (0.12-0.35 in).
6. Adjust the gap between the rear of the door and the rear pillar to 3.0-5.0 mm (0.12-0.20 in).
7. Adjust the gap between the door and the fender to 4.0-6.0 mm (0.16-0.24 in).
8. Adjust the door surfaces so that the door surfaces are flush with the other panels to 1.0 mm (0.04 in).

NOTE: Refer to Fastener Notice in Service Precautions.

9. Tighten the hinge bolts.

Tighten
Tighten the hinge bolts to 35 N.m (26 lb ft).

10. Install the door striker bolt.

Adjust
Adjust the bolt in order to properly engage the door lock.

Tighten
Tighten the bolt to 63 N.m (46 lb ft).