Reduction and Drive Group Disassembly

1. Disassemble the housing bolts.
2. Disassemble the armature support bracket.

IMPORTANT: Washers may stick to the bracket or to the driveshaft and the clutch group as the bracket is removed. In either case, note the position and the number of each of these washers.

3. Disassemble the washers.
4. Disassemble the drive housing plug and plate. Pry out the housing plug with a large flat-bladed tool.
5. Disassemble the following components:
- The shift lever nut
- The washer
- The screw
6. Disassemble the shift lever and the driveshaft and clutch group from the drive housing together. Then separate these components. Do not remove the bushing plug or the bushing from the drive housing unless replacement is necessary.