Ignition & Key Alarm Switch - Assemble

ASSEMBLY PROCEDURE





1. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
- Tighten the screws to 4.7 Nm (42 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the key alarm connector (1) onto the lock module assembly (2).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulk head connector (1).





4. Pop the wire harness assembly (4) into the wire harness strap (5).
5. Install the wire harness strap (2) into the steering column support assembly (1).
6. Install the wire harness straps (3) onto the wire harness assembly (4).
7. Install the upper and lower shrouds.