Ignition & Key Alarm Switch - Assemble

ASSEMBLY PROCEDURE





1. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
- Tighten the screws to 4.7 Nm (42 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the key alarm connector (1) onto the lock module assembly (2).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulk head connector (1).
4. Install the upper and lower shrouds.