Shift Lever Seal

REMOVAL PROCEDURE
1. Remove the TORX head screws from the lower column cover.
2. Do not remove the cover.
Allow pivoting of the lower column cover on the upper column cover.
3. Roll the seal back until the TORX head screw is exposed.
4. Remove the TORX head screw from the shift lever.
5. Remove the shift lever.
6. Remove the shift lever seal.

INSTALLATION PROCEDURE
1. Install the shift lever seal.
2. Install the shift lever.
3. Install the TORX head screw to the shift lever.
- Tighten the screw to 22 Nm (16 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

4. Roll the seal up the lever until the TORX head screw is covered.
5. Install the TORX head screws to the lower column cover.
- Tighten the screws to 6 Nm (53 inch lbs.).