Operation CHARM: Car repair manuals for everyone.
Home >> Chevy Truck >> 1999 >> C 3500 Truck 2WD V8-6.5L DSL Turbo VIN S >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> 4L80-E/4L85-E Automatic Transmission >> Repair Instructions >> 92. Control Valve Body Assembly Assemble

92. Control Valve Body Assembly Assemble





1. Install the 3-4 shift valve spring (309).
2. Install the 3-4 shift valve (308).
3. Install the 3rd ball valve bushing (335) and 3rd ball valve bushing seal (307).
4. Install the 3rd-reverse ball valve (305).
5. Install the reverse ball valve bushing (334).
6. Install the 3rd-reverse ball valve seat pin (303).





7. Install the 2-3 shift valve spring (309).
8. Install the 2-3 shift valve (312).
9. Install the 2-3 shift valve pin (303).
10. Install the 2-3 shift solenoid valve (311).

Notice: Refer to Fastener Notice in Service Precautions.

11. Install the 2-3 shift solenoid valve bolt (310).
^ Tighten the bolt to 8 Nm (71 lb in).





12. Install the 1-2 shift valve spring (315).
13. Install the 1-2 shift valve (314).
14. Install the 1-2 shift valve pin (303).
15. Install the 1-2 shift solenoid valve (313).
16. Install the 1-2 shift solenoid valve bolt (310).
^ Tighten the bolt to 8 Nm (71 lb ft).





17. Install the shift solenoid valve fluid filter (317).
18. Install the shift valve fluid filter bore plug (316).
19. Install the shift valve fluid filter bore plug pin (303).





20. Install the low-reverse ball valve (305).
21. Install the low-reverse ball valve seat (304).
22. Install the low-reverse ball valve seat pin (318).





23. Install the pressure control solenoid valve fluid filter (302).





24. Install the accumulator valve (331).
25. Install the accumulator valve spring (330).
26. Install the accumulator valve bore plug (329).
27. Install the accumulator valve bore plug retainer pin (303).





28. Install the actuator feed limit valve (328).
29. Install the actuator feed limit valve spring (327).
30. Install the actuator feed limit valve spring retainer (333).





31. Install the TCC regulator apply valve spring (325).
32. Install the TCC regulator apply valve (324).
33. Install the TCC regulator apply valve pin (303).
34. Install the TCC PWM solenoid valve (323).





35. Install the TCC PWM solenoid valve retainer (322).
36. Install the pressure control solenoid valve (320) with the electrical connector facing away from the control valve body.
37. Install the pressure control solenoid clamp (321).
38. Install the pressure control solenoid clamp bolt (310).
^ Tighten the bolt to 8 Nm (71 lb in).
pro multis · About Operation CHARM