10.5 Inch Axle

Removal Procedure





1. Remove the bolts (6).
2. Lightly rap the axle shaft flange with a soft-faced hammer in order to loosen the shaft.
3. Grip with a locking pliers the rib on the axle shaft flange and twist in order to start the axle shaft (5) removal.
4. Remove the axle shaft (1) from the tube.
5. Clean the axle shaft flange.
6. Remove the gasket (4) and RTV.
7. Clean the outside face of the hub assembly (3).
8. Inspect all parts and replace as necessary.


Installation Procedure





1. Install the axle shaft (5) with a gasket (4) or RTV applied.
^ Be sure the shaft splines mesh into the differential side gear.
^ Align the holes in the axle shaft flange with the holes in the hub (3).
2. Install the bolts (6).
^ Tight the bolts (6) to 150 Nm (110 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.