A/T - 4T65-E Fluid Leaks From Reverse Servo Cover
Bulletin No.: 04-07-30-028ADate: January 12, 2006
TECHNICAL
Subject:
4T65-E Automatic Transmission Fluid Leak From Reverse Servo Cover (Replace Reverse Servo Cover Seal)
Models:
2005 and Prior Cars and Light Duty Trucks
with Automatic Transmission 4T65-E (RPOs MN3, MN7, M15, M76)
Supercede:
This bulletin is being revised to announce an improved reverse servo cover seal is available from GMSPO and to advise technicians that it is no longer necessary to replace the reverse servo cover when replacing the seal. The 2005 model year vehicles are also being added. Please discard Corporate Bulletin Number 04-07-30-028 (Section 07 - Transmission/Transaxle).
Condition
Some customers may comment on a fluid leak under the vehicle. A transmission fluid leak may be noted during the Pre-delivery Inspection (PDI).
Cause
A possible cause of a transmission fluid leak usually only during cold ambient temperatures below -6.7°C (20°F) may be the reverse servo cover seal. The reverse servo cover seal may shrink in cold ambient temperatures causing a transmission fluid leak.
Correction
Follow the diagnosis and repair procedure below to correct this condition.
1. Diagnose the source of the fluid leak.
2. If the source of the transmission fluid leak is the reverse servo cover, replace the reverse servo cover seal with P/N 24235894. Refer to Reverse Servo Replacement in the appropriate Service Manual.
3. Clean the area around and below the cover.
4. Inspect the transmission fluid level. Refer to Transmission Fluid Checking Procedure in the appropriate Service Manual.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer