Hazard Warning Lamps: Service and Repair
Emergency Roof Lamp Switch ReplacementREMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the knee bolster.
3. Disconnect the electrical connector (4).
4. Remove the retainer (3) from the rear of the faceplate.
5. Remove the switch from the faceplate.
INSTALLATION PROCEDURE
1. Install the switch to the faceplate.
2. Install the retainer (3).
2.1. Align the indexing tab on the nut to the tab on the switch (1).
2.2. Slide the nut to the faceplate until the nut snaps into position.
3. Connect the electrical connector (4).
4. Install the knee bolster.
5. Connect the negative battery cable.