Electronic Column Lock Module - Assemble

ASSEMBLY PROCEDURE





1. Install the lock bolt spring (3) into the steering column housing assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column housing assembly (5).
4. Push the lock bolt assembly (4) into the steering column housing assembly (5) until the lock bolt assembly is flush with the steering column housing assembly (5).
5. Align the lock module assembly (2) with the steering column housing assembly (5).
Install the lock module assembly (2) onto the steering column housing assembly (5).
6. Screw the 3 pan head tapping screws (1) into the lock module assembly (2).
- Tighten the 3 pan head tapping screws to 7 Nm (62 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.





7. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
- Tighten the screws to 4.7 Nm (42 inch lbs.).
8. Install the key alarm connector (1) onto the lock module assembly (2).
9. Install the upper head components.