13. Low and Reverse Band Servo Pin Check

^ Tools Required
- J 21370-10 Band Apply Pin Gage
- J 38737 Band Apply Pin Checking Tool





1. Install the J 21370-10 into the low and reverse band servo pin bore.
2. Position the J 38737 over the low and reverse band servo bore with the hex hub facing the parking pawl linkage.

Notice: Refer to Fastener Notice in Service Precautions.

3. Fasten the J 38737 to the case with two low and reverse band servo cover bolts.
^ Tighten the bolts to 24 Nm (18 lb ft).
4. Verify that the J 21370-10 moves freely in the J 38737 and in the low and reverse band servo pin bore.
5. In order to determine the correct low and reverse band servo pin length, apply 34 Nm (25 lb ft) of torque to the hex hub of the J 38737.
6. Observe the lands on the J 21370-10 in order to see which land is even with the top edge of the J 38737 and note the letter (A, B or C) stamped on the J21370-10.
7. Refer to the Low and Reverse Band Servo Pin Specification chart in order to determine the correct low and reverse band servo pin length to use.