18. Pump Assembly Removal

^ Tools Required
- J 23129 Universal Seal Remover
- J 6125- 1B Slide Hammer
- J 37789-A Oil Pump Remover/Installer





1. Remove the turbine shaft front oil seal ring (2).





2. Remove the torque converter oil seal assembly (201) using the J 23129 and the J 6125-1B.





3. Remove the seven oil pump bolt and seal assemblies (3).
4. Attach the J 37789-A to the oil pump shaft.
Tighten the thumb screw.
5. Turn the handle of the J 37789-A down onto the turbine shaft in order to raise the oil pump assembly (4) out of the case.
6. Remove the oil pump assembly (4).
7. Remove the J 37789-A.





8. Remove the transmission oil pump gasket (6).

Important: The selective thrust washer (218) may be stuck to the pump cover.

9. Remove the selective thrust washer (218).