66. Turbine Shaft Assemble

^ Tools Required
- J 38736-1 Turbine Shaft Seal Installer
- J 38736-2 Turbine Shaft Seal Installer
- J 38736-3 Turbine Shaft Seal Sizer
- J 38736-4 Turbine Shaft Seal Sizer
- J 38736-5 Turbine Shaft Seal Pusher
- J 38736-6 Turbine Shaft Seal Pusher





1. Place the J 38736-1 onto the turbine shaft (502).
2. Set the J 38736-1 to position #11.
3. Install the turbine shaft rear oil seal ring (501) using the J 38736-5.
4. Remove the tools.





Important: Be sure to use the small chamfered end of the J 38736-3 in order to size the lower turbine shaft rear oil seal ring. Then use the larger chamfered end of the J 38736-3 in order to size the upper turbine shaft rear oil seal ring.

5. Place the J 38736-3 over the turbine shaft rear oil seal ring with the small chamfer down.
6. Leave the J 38736-3 on the turbine shaft rear oil seal ring for at least one minute in order to allow the turbine shaft rear oil seal ring to become the proper size.





7. Place the J 38736-1 onto the turbine shaft (502).
8. Set the J 38736-1 to position #2.
9. Install the turbine shaft rear oil seal ring (501) using the J 38736-5.
10. Remove the tools.





11. Place the J 38736-3 over the turbine shaft rear oil seal ring with the large chamfer down.
12. Leave the J 38736-3 on the turbine shaft rear oil seal ring for at least one minute to allow the turbine shaft front oil seal to become the proper size.





13. Turn the turbine shaft (502) over.
14. Place the J 38736-2 onto the turbine shaft.
15. Set the J 38736-2 to position #11.
16. Install the turbine shaft intermediate oil seal ring (503) using the J 38736-6.
17. Remove the tools.





Important: Be sure to use the small chamfered end of the J 38736-4 in order to size the lower turbine shaft intermediate oil seal ring. Then use the larger chamfered end of the J 38736-4 in order to size the upper turbine shaft intermediate oil seal ring.

18. Place the J 38736-4 over the turbine shaft intermediate oil seal ring with the small chamfer down.
19. Leave the J 38736-4 on the turbine shaft intermediate oil seal ring for at least one minute in order to allow the turbine shaft intermediate oil seal ring to become the proper size.





20. Place the J 38736-2 onto the turbine shaft (502).
21. Set the J 38736-2 to position #2.
22. Install the turbine shaft intermediate oil seal ring (503) using the J 38736-6.
23. Remove the tools.





24. Place the J 38736-4 over the turbine shaft intermediate oil seal ring with the large chamfer down.
25. Leave the J 38736-4 on the turbine shaft intermediate oil seal ring for at least one minute in order to allow the turbine shaft intermediate oil seal ring to become the proper size.