8.6 & 9.5 Inch Axle

^ Tools Required
- J 26252 Governor Remover





1. Remove the governor bushing using the J 26252.





2. Remove the E-clips that hold the latching bracket on the shah. Move the bracket down the shah.
3. Remove the latching bracket bushing using the J 26252.
4. Remove the latching bracket, the shaft, and the spring from the case.
5. Remove the governor assembly from the case.
6. Remove the lock screw.
7. Remove the pinion shaft.
8. Remove the differential pinion gear and pinion thrust washer. Rotate one of the side gears and roll the gears out of the case.
9. Remove the thrust block and the right side gear.
10. Remove the right clutch plates and the side thrust washer.
11. Remove the left side gear, the cam plate, and the clutch plates as an assembly (cam unit).
12. Remove the side gear thrust washer.