Power Antenna Assembly Replacement

REMOVAL PROCEDURE




1. Remove the quarter inner rear trim finishing panel.
2. Remove the spare tire and jack.
3. Disconnect the antenna cable (4) from the power antenna.
4. Disconnect the power antenna electrical connector (3).
5. Remove the drain tube (1) from the grommet in the rear quarter panel.
6. Remove the power antenna bracket bolt (2).
7. Pull down the bracket. Disengage the power antenna from the antenna bezel.
8. Remove the power antenna.
9. Unsnap the bezel from the rear quarter panel.
10. Remove the antenna bezel.

INSTALLATION PROCEDURE




1. Snap the bezel into the rear quarter panel in order to install the antenna bezel.
2. Install the power antenna.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the power antenna bracket bolt (2).

Tighten
Tighten the power antenna bracket bolt to 5 N.m (44 lb in).

4. Install the drain tube (1) to the grommet in the rear quarter panel.
5. Connect the power antenna electrical connector (3).
6. Connect the antenna cable (4) to the power antenna.
7. Install the jack and the spare tire.
8. Install the quarter inner rear trim finishing panel.