Blower Motor Replacement - Auxiliary

REMOVAL PROCEDURE




1. Remove the body side front lower trim panel.

IMPORTANT: Note the location of the blower motor electrical connectors before disconnecting them.

2. Disconnect the blower motor electrical connectors.
3. Remove the retaining screws.

IMPORTANT: Note the orientation of the blower motor assembly before removing the assembly from the case.

4. Remove the blower motor assembly from the blower case.

INSTALLATION PROCEDURE




1. Install the blower motor assembly to the blower case.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the blower motor retaining screws.

Tighten
Tighten the blower motor retaining screws to 4 N.m (35 lb in).

3. Connect the blower motor electrical connectors.
4. Install the body side front lower trim panel.