Electronic Column Lock Module - Disassemble

Electronic Column Lock Module -Disassemble - Off Vehicle (Tilt Column)

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the inflatable restraint steering wheel module.
2. Remove the ignition lock cylinder.
3. Remove the upper tilt head components.
4. Remove the ignition and key alarm switch assembly only.
5. Remove the park lock cable assembly (1) from the electronic lock module assembly.
5.1. Place the steering column lock cylinder set into the OFF position.
5.2. Place the shift lever clevis into the PARK position.
5.3. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
5.4. Disconnect the park lock cable assembly (1) from the electronic lock module assembly.





6. Remove the 3 pan head tapping screws (1) from the electronic lock module assembly (2).

Important: The lock bolt assembly (4) is under slight spring tension from the lock bolt spring (3). Hold the lock bolt (4) in place while removing the electronic lock module assembly (2).

7. Remove the electronic lock module assembly (2) and the lock bolt assembly (4) from the steering column tilt head assembly (5).
8. Remove the lock bolt spring (3) from the lock bolt assembly (4).