Body Side Stationary Window Replacement

Body Side Stationary Window Replacement


Tools Required
* J 24402-A Glass Sealant (Cold Knife) Remover
* J 39032 Stationary Glass Removal Tool
* Urethane Adhesive Kit GM P/N 12346392 or Equivalent
* Isopropyl Alcohol or Equivalent
* Cartridge-type Caulking Gun
* Commercial-type Utility Knife
* Razor Blade Scraper
* Suction Cups
* Plastic Paddle



Removal Procedure


Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.


Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.


1. When replacing or removing the left side stationary window refer to interior trim for removal. Refer to Trim Replacement - Third Pillar Left (Trim Replacement - Third Pillar Left) in Interior Trim or Trim Replacement - Fourth Pillar Left (Trim Replacement - Fourth Pillar Left) in Interior Trim.
2. When replacing or removing the right side stationary window refer to interior trim for removal. Refer to Trim Replacement - Third Pillar Right (Trim Replacement - Third Pillar Right) in Interior Trim or Trim Replacement - Fourth Pillar Right (Trim Replacement - Fourth Pillar Right) in Interior Trim.

Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

3. Cover to protect the following parts from broken glass:

1. Upper dash pad
2. Defroster outlets and A/C outlets
3. Seats and carpeting






Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

4. Using a sharp utility knife, make a preliminary cut around the perimeter of the stationary window.





Important: Keep the cutting edge of the tool against the stationary window. Do this from inside the vehicle.


5. This will allow the urethane adhesive to be separated from the stationary window.

* Leave a base of urethane on the pinchweld flange.
* The only suitable lubrication is clear water.
* Use J 24402-A , J 39032 or equivalent in order to remove the stationary window.





6. With the aid of an assistant, remove the stationary window from the opening.



Installation Procedure

1. Install the stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows (Urethane Adhesive Installation of Stationary Windows) .
2. When replacing or removing the left side stationary window refer to interior trim for removal. Refer to Trim Replacement - Third Pillar Left (Trim Replacement - Third Pillar Left) in Interior Trim or Trim Replacement - Fourth Pillar Left (Trim Replacement - Fourth Pillar Left) in Interior Trim.
3. When replacing or removing the right side stationary window refer to interior trim for removal. Refer to Trim Replacement - Third Pillar Right (Trim Replacement - Third Pillar Right) in Interior Trim or Trim Replacement - Fourth Pillar Right (Trim Replacement - Fourth Pillar Right) in Interior Trim.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.