Blower Motor Replacement

BLOWER MOTOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the right closeout/insulator panel.
2. Remove the I/P storage compartment door.




3. Disconnect the blower motor electrical connector.
4. Remove the blower motor mounting screws.
5. Remove the blower motor cooling tube.
6. Remove the blower motor (2).

INSTALLATION PROCEDURE




1. Install the blower motor (2).
2. Install the blower motor cooling tube.
3. Install the blower motor mounting screws.

Tighten the screws to 2 N.m (18 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Connect the blower motor electrical connector.
5. Install the right closeout/insulator panel.