54. Oil Pump Assemble
Oil Pump Assemble
^ Tools Required
- J 22144 Oil Suction Pipe Installer
1. Lubricate all the internal oil pump parts using engine oil during assembly.
2. Install the oil pump gears.
3. Install the oil pump cover.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil pump cover bolts.
^ Tighten the oil pump cover bolts to 10 Nm (89 inch lbs.).
5. Install the pressure regulator valve.
6. Install the pressure regulator spring.
7. Install the cotter pin.
8. Important: Make sure the cotter pin is properly secured.
Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or the equivalent to the new suction pipe.
9. Tap the new suction pipe into place using J 22144 and a plastic hammer.