Inflatable Restraint Roof Side Rail Module Replacement - Front

INFLATABLE RESTRAINT ROOF RAIL MODULE REPLACEMENT - FRONT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or to SIR Disabling and Enabling Zone 6.

CAUTION:
- Refer to SIR Caution in Service Precautions.
- Use care when working around the roof rail inflator module because sharp objects may puncture the roof rail airbag and the airbag will not deploy correctly.

In order to avoid personal injury, if any part of the module is damaged replace the entire module

2. Remove the headliner and the garnish moldings from the vehicle.
3. Unsnap the SIR tether retainer and remove the tether from the windshield pillar.

IMPORTANT: Remove all clips and plastic guides from the structure. Clips are designed for single usage only. The new inflator assembly will contain new clips and plastic guides.




4. Remove the SIR module fasteners from the inflator retention tabs and clips. Remove the SIR module from the vehicle.

INSTALLATION PROCEDURE




1. Unpack the new inflator assembly. Start at the rear of the vehicle and install the inflator module to the structure with integral T-locator and fasteners.

IMPORTANT: Position the module tether rearward of the molding attaching clips.

Tighten the fasteners to 5 N.m (44 lb in).

2. Working from the rear of the vehicle, install the retaining tabs to the structure to hold the inflator module in place.
3. Install the remaining side SIR module fasteners.

NOTE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: Visually inspect the side curtain to assure that the curtain is not twisted.

4. Install the hook on the curtain tether to the windshield pillar. Snap the hook retainer into place.
5. Install the headliner and the garnish moldings to the vehicle.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or to SIR Disabling and Enabling Zone 6.
7. After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.