110. Park/Neutral Position Switch Installation

Park/Neutral Position Switch Installation

^ Tools Required
- J 45404 Transmission Indicator Alignment Tool





1. Install the park/neutral position switch (75) to the manual shift detent lever assembly.
2. Install the park/neutral position switch stud (76), bolt (79), and flat washers (69) and hand tighten until tight enough to hold the park/neutral position switch in place, but still loose enough to allow adjustment by hand.





Notice:
Refer to Fastener Notice in Service Precautions.

3. Install the park/neutral position switch flat washer (74), lock tab washer (77), and nut (78).
Tighten the park/neutral position switch nut to 7 Nm (62 lb in).





4. Bend the tabs on the lock tab washer to secure the nut.





5. Place the manual shift detent lever assembly in the Neutral (N) position.
6. Install the J 45404 to the manual shift detent lever assembly.
7. Rotate the park/neutral position switch until the neutral base line on the switch assembly lines up with the indicator line on J 45404.
8. Tighten the park/neutral position switch stud (76) and the park/neutral position switch bolt (79).
Tighten the park/neutral position switch stud and bolt to 25 Nm (18 lb in).
9. Remove J 45404 from the manual shift detent lever assembly.