Operation CHARM: Car repair manuals for everyone.

Linkage Replacement - Endgate



Linkage Replacement - Endgate

Removal Procedure




1. Lower the endgate.
2. Loosen the endgate handle bolts. Refer to Handle Replacement - Endgate.
3. Raise the endgate.




4. Remove the handle bezel by prying gently on the upper retainer tabs.
5. Lower and support the endgate.
6. Remove the endgate latch assembly.




7. Disengage the linkage rod from the latch assembly.




8. Remove the linkage rod (1) from the endgate handle assembly.

Installation Procedure




1. Install the linkage rod to the endgate handle assembly.




2. Engage the linkage rod (1) to the latch assembly.
3. Install the endgate latch assembly.
4. Raise the endgate.




5. Install the endgate handle bezel. Pressing into place until fully seated.





Notice: Refer to Fastener Notice in Service Precautions.

6. Tighten the endgate handle bolts.

Tighten the handle bolts to 25 N.m (18 lb ft).