Power Steering Gear Inlet Pipe/Hose Replacement (With Hydroboost)

Power Steering Gear Inlet Pipe/Hose Replacement (With Hydroboost)

Removal Procedure





1. Install a drain pan under the vehicle.

Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.

2. Remove the power steering gear inlet hose (1) from the brake booster.
3. Remove the power steering gear inlet hose from the power steering gear.
4. Remove the power steering gear inlet hose from the vehicle.

Installation Procedure





1. Route the hose in the same position the hose occupied prior to removal.

Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.

2. Install the power steering gear inlet hose (1) to the brake booster (2). Hand tighten only.

3. Install the power steering gear inlet hose to the power steering gear.
^ Tighten both power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.