Instrument Panel Insulator Panel Replacement - Left Side

Instrument Panel Insulator Panel Replacement - Left Side

Removal Procedure




1. Remove the 2 screws that retain the insulator panel to the instrument panel (I/P).
2. Release the insulator panel retaining clip from the I/P substrate.
3. Lower the insulator panel.




4. Remove the 2 data link connector (DLC) retaining screws.
5. Remove the DLC from the insulator panel.
6. Remove the splice pack from the insulator panel.
7. Remove the hazard and turn signal flasher from the insulator panel.
8. Remove the insulator panel from the I/P.

Installation Procedure




1. Position the insulator panel to the I/P.
2. Install the hazard and turn signal flasher to the insulator panel.
3. Install the splice pack to the insulator panel.
4. Position the DLC to the insulator panel.

Notice: Refer to Fastener Notice.

5. Install the DLC retaining screws.

Tighten the DLC retaining screws to 2.5 N.m (22 lb in).




6. Install the insulator panel tabs to the cowl slots.




7. Raise the insulator panel to the I/P.
8. Install the insulator panel retaining clip to the I/P substrate.
9. Install the 2 screws that retain the insulator panel to the I/P.

Tighten the screws to 2.5 N.m (22 lb in).