Operation CHARM: Car repair manuals for everyone.

Cargo Door Ajar Indicator Malfunction




Cargo Door Ajar Indicator Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

Diagnostic Fault Information





Circuit/System Description

The body control module (BCM) monitors each door ajar circuit to indicate the status of the door. When the respective door is opened, the door ajar signal circuit is switched to ground by the door lock ajar indicator switch, the BCM detects the drop in voltage in the circuit and then communicates this status to the instrument panel cluster (IPC) via a serial data message. The IPC, upon receipt of this serial data message, will illuminate the appropriate ajar message in the driver information center (DIC) and when the transmission is shifted out of PARK, the DIC will also send a serial data message to the radio to activate the door ajar audible warning.

Reference Information
Schematic Reference

Door Lock/Indicator Schematics (Door Lock/Indicator Schematics)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Door Ajar Indicator Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Observe the scan tool Rear Closure Ajar Sw parameter while opening and closing the rear cargo door. The parameter should change between Active and Inactive.

Circuit/System Testing

1. Ignition OFF, disconnect the X1 harness connector at the cargo door latch.
2. Test for less than 1 ohm between the ground circuit terminal A and ground.

If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool Rear Closure Ajar Sw parameter is Inactive.

If not the specified value, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the BCM.

4. Install a 3A fused jumper wire between the signal circuit terminal C and ground.
5. Verify the scan tool Rear Closure Ajar Sw parameter is Active.

If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

6. If all circuits test normal, test or replace the cargo door latch.

Component Testing

1. Ignition OFF, disconnect the X1 harness connector at the cargo door latch.
2. Test for infinite resistance between the signal terminal C and the ground terminal A with the door ajar switch in the open position.

If not the specified value, replace the cargo door latch.

3. Test for less than 2 ohms between the signal terminal C and the ground terminal A with the door ajar switch in the closed position.

If greater than the specified range, replace the cargo door latch.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for BCM replacement, setup and programming