5. 2-4 Servo Cover and Assembly Removal

2-4 Servo Cover and Assembly Removal

Special Tools

J 29714-A - Servo Cover Depressor

For equivalent regional tools, refer to Special Tools (4L60-E/4L65-E/4L70-E - Automatic Transmission).




1. Install the J 29714-A - depressor.





Note: If cover does not move inwards with tool, use a block of wood or suitable material and lightly tap on cover using a hammer to free up cover in bore.

2. Tighten the J 29714-A - depressor bolt to compress the servo cover.




3. Remove the servo cover retaining ring (29) and the J 29714-A - depressor.




4. Remove the servo cover (28) and O-ring seal (27). If the servo cover seems to be hung up on the seal, cut and remove the O-ring seal before removing the cover.
5. Remove the 2-4 servo assembly.