Rear Seat Radio Controls Inoperative

Rear Seat Radio Controls Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovide an overview of each diagnostic category.

Reference Information
Schematic Reference

Radio/Navigation System Schematics Radio/Navigation System Schematics
Connector End View Reference

Component Connector End Views Connector End Views By Name
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearningfor scan tool information

Circuit/System Verification

Radio ON, verify clear audio is heard from each audio speaker with the RSA system OFF.

If audio is inoperative from one or all speakers, refer to Speaker Malfunction Speaker Malfunction.

Circuit/System Testing

1. Ignition OFF, disconnect the X1 harness connector at the rear seat audio (RSA) controller.
2. Test for less than 5 ohms between the ground circuit terminal 6 and ground.

• If greater than the specified range, test the ground circuit for an open/high resistance.

3. Radio ON, test for battery voltage between the battery positive voltage circuit terminal 5 and ground.

• If less than the specified range, test the voltage circuit for a short to ground or an open/high resistance.

4. If all circuits test normal, replace the rear seat audio controller.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Rear Seat Audio Control Replacement Rear Seat Audio Control Replacement