Non-Hybrid Less than 3900 kg (8600 lb) GVW

Rear Wheel Speed Sensor Replacement

Removal Procedure
Warning: Refer to Brake Dust Warning Brake Dust Warning.


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.




2. Disconnect the wheel speed sensor electrical connector (1).
3. Release the wheel speed sensor electrical connector and sensor harness clips (2) from the inboard frame rail.




4. Remove the wheel speed sensor bolt (1).




5. Remove the wheel speed sensor (1) from the rear axle.

Installation Procedure




1. Install the wheel speed sensor (1) to the rear axle.





Caution: Refer to Fastener Caution Fastener Caution.

2. Install the wheel speed sensor bolt (1) and tighten to 9 Nm (80 lb in).




3. Connect the wheel speed sensor electrical connector (1).
4. Install the wheel speed sensor electrical connector and sensor harness clips (2) to the inboard frame rail.
5. Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle.