Power Steering Pump Pulley Replacement

Power Steering Pump Pulley Replacement

Tools Required
* J 25033-C Pulley Installer
* J 25034-C Pulley Remover

Removal Procedure

1. Remove the engine coolant fan upper shroud, if equipped. Refer to Engine Coolant Fan Upper Shroud Replacement Engine Coolant Fan Upper Shroud Replacement.
2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory Drive Belt Replacement - Accessory.




3. Use remover J 25034-C to remove the power steering pump pulley.

Installation Procedure




1. Place the power steering pump pulley on the end of the power steering pump shaft.
2. Install the power steering pump pulley using installer J 25033-C .




3. Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2) with an allowable variance of 0.25 mm (0.010 in).
4. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory Drive Belt Replacement - Accessory.
5. Install the engine coolant fan upper shroud, if equipped. Refer to Engine Coolant Fan Upper Shroud Replacement Engine Coolant Fan Upper Shroud Replacement.