Front Axle Will Not Engage

Front Axle Will Not Engage

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

Circuit/System Description

The front axle control circuit consists of an electric motor actuator which engages and disengages the front axle. The front axle actuator motor consists of a permanent magnetic motor, a worm gear controlled plunger, a front axle switch and an electronic control circuit within the actuator assembly.

The front axle actuator consists of the following circuits:

* The front axle control circuit, which is also connected to the transfer case shift control module
* The front axle switch circuit, which is also connected to the transfer case shift control module
* An ignition 3 voltage circuit
* A ground circuit

When a shift to AUTO 4WD, 4HI, or 4LO is requested, the transfer case shift control module engages the front axle by grounding the front axle control circuit through a current limiting driver.

Reference Information
Schematic Reference

Transfer Case Control Schematics MP 3023/3024-NQH - Transfer Case
Connector End View Reference

Component Connector End Views Connector End Views By Name
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearningfor scan tool information.

Circuit/System Testing

1. If this is occurring without DTC C0379 setting it is likely related to a mechanical issue. Refer to Four-Wheel Drive Does Not Engage Four-Wheel Drive Does Not Engage.
2. If no mechanical issue is found replace the front axle actuator.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Control Module References Programming and Relearningfor TCSCM replacement, setup, and programming
* Transfer Case High/Low Clutch Reset Transfer Case High/Low Clutch Reset
* Four-Wheel Drive Does Not Engage Four-Wheel Drive Does Not Engage
* Four-Wheel Drive Does Not Disengage Four-Wheel Drive Does Not Disengage
* Front Drive Axle Actuator Replacement Service and Repair