Evaporative Emission Canister Replacement (1500 Series)

Evaporative Emission Canister Replacement (1500 Series)

Removal Procedure

Note: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the EVAP canister bracket bolts and lower the EVAP canister.
3. Disconnect the fuel tank EVAP line quick connect fittings (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.




4. Disconnect the EVAP canister vent solenoid quick connecting fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.




5. Remove the EVAP canister.
6. If necessary, remove the EVAP canister to bracket bolt.
7. If necessary, remove the EVAP canister from the bracket.

Installation Procedure




1. If necessary, install the EVAP canister to the bracket.

Caution: Refer to Fastener Caution Fastener Caution.

2. If necessary, install the EVAP canister to bracket bolt.

Tighten the bolt to 25 Nm (18 lb ft).

3. Position the EVAP canister.




4. Connect the EVAP canister vent solenoid quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.




5. Connect the fuel tank EVAP line quick connect fittings (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.
6. Install the EVAP canister bracket bolts.

Tighten the bolts to 25 Nm (18 lb ft).

7. Lower the vehicle.