B1643

B1643-REAR LEFT TURN CONTROL CIRCUIT LOW





For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
- With the Turn Signal activated.
- Set Condition:
- When the TIPM detects a LOW condition.





Diagnostic Test

1. INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all TIPM DTC's.
Turn the Left Turn Signals on.
With the Scan Tool read the DTC information.
Does the Scan Tool read: B1643-REAR LEFT TURN CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST-VER1. Body Verification Test

2. (L63) LEFT TURN SIGNAL CONTROL CIRCUIT




Turn the ignition off.
Disconnect the TIPM C3 connector.
Disconnect the Left Rear Tail Lamp connector.
Measure the resistance between ground and the (L63) Rear Left Rear Turn Signal Control circuit.
Is the resistance below 5.0 ohms?

Yes

- Repair the (L63) Rear Left Turn Signal Control circuit for a short to ground.
- Perform the BODY VERIFICATION TEST-VER1. Body Verification Test

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST-VER1. Body Verification Test