P1278

P1278-STARTER CONTROL CIRCUIT 2 HIGH (TIPM)





For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on. Battery voltage greater than 10.4 volts and the ASD sense switch is on.

- Set Condition:
Actual Starter state is not equal to desired state. One Trip Fault. Three good trips to turn off the MIL.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Initial Inspection and Diagnostic Overview.

Diagnostic Test

1. ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read DTCs.
Is the DTC active at this time?

Yes

- Go To2

No

- Refer to the INTERMITTENT CONDITION Diagnostic Procedure.Intermittent Condition
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

2. (T40) STARTER FEED CIRCUIT SHORTED TO BATTERY VOLTAGE
Turn the ignition off.
Disconnect the Starter Relay.
Disconnect the C10 TIPM harness connector.
Turn the ignition on.
Measure the voltage of the (T40) Starter Relay Output circuit in the C10 TIPM harness connector.
Is the resistance below 100 ohms?

Yes

- Repair the short to voltage in the (T40) Starter Relay Output circuit.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

No

- Go To 3

3. (T750) STARTER RELAY OUTPUT CIRCUIT SHORTED TO BATTERY VOLTAGE
Disconnect the Starter Solenoid connector.
Measure the voltage of the (T750) Starter Relay Output circuit in the Starter Relay harness connector.
Is the resistance below 100 ohms?

Yes

- Repair the short to voltage in the (T750) Starter Relay Output circuit.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

No

- Go To 4

4. STARTER
Reconnect the Starter Solenoid harness connector.
Using a 12-volt test light connected ground, probe the (T750) Stater Relay Output circuit in the Starter Relay harness connector.
Crank the engine.
Does the test light illuminate?

Yes

- Replace the Starter
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

No

- Go To 5

5. STARTER RELAY INTERNAL SHORT
Install a substitute relay in place of the Starter Relay.
Reconnect the C10 TIPM harness connector.
Crank the engine.
With a scan tool, read DTCs.
Does the DTC reset?

Yes

- Replace the TIPM.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

No

- Replace the Starter Relay.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test