Installation

INSTALLATION





1. Install shifter assy. (1) to floor pan. Install and tighten four nuts to 12 Nm (105 in. lbs.) torque.




2. Install selector cable (3) to shifter lever and secure cable to shifter bracket. Install clip (2).




3. Install crossover cable (3) to shifter lever and secure cable to shifter bracket. Install clip (4).

NOTE: Only the crossover cable is adjustable. The selector cable does not have any adjustment capabilities.

4. Adjust crossover cable. Adjustments




5. Install center console assembly. Install rear power window switch (if equipped) and fasten harness to console.




6. Position gearshift boot (1) over the gearshift mechanism and engage tab on mount ring at front to opening in console. Apply hand pressure to engage bosses on mount ring of boot to console opening slots.




7. Position gearshift knob hole over the gearshift mechanism and align the shift pattern.
8. Verify that shift pattern is aligned properly.
9. Strike knob (1) with rubber mallet to engage knob to mechanism.