Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 1987 >> Conquest L4-2555cc 2.6L Turbo VIN H FI >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Crankshaft Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Crankshaft Position Sensor: Service and Repair



REMOVAL
1. Disconnect battery ground cable.
2. Disconnect distributor wiring harness, then lift off distributor cap with ignition cables attached and position aside.
3. Disconnect vacuum hose at vacuum control unit.
4. Remove distributor mounting bolt, then the distributor assembly.


Fig. 5 Distributor housing to driven gear alignment:




Fig. 6 Distributor installation:






INSTALLATION
1. Rotate crankshaft until piston of No. 1 cylinder is at top dead center on compression stroke.
2. Align mating mark line on distributor housing with punch mark on distributor gear, Fig. 5.
3. Install distributor onto cylinder head.
4. Align mating mark on distributor attaching flange with center of distributor flange stud, Fig. 6.
5. Install mounting nut, then install vacuum hose(s), wiring harness and distributor cap.
6. Check and reset ignition timing as necessary. Refer to ``Tune Up'' for procedure.


pro multis · About Operation CHARM