Glass Panel Removal

REMOVAL
1. Remove wind deflector mechanism covers.
2. Position glass to vent position.
3. Position sunshade fully rearward.
4. Partially unscrew six connecting nuts (three each side) securing glass panel to side adjustment brackets.
5. Slide glass panel rearward approximately 12 mm (1/2") and lift off.

INSTALLATION
1. Install glass panel and slide panel forward 12 mm (1/2"), logo stenciled on glass, toward rear of car.
2. Verify that six glass panel attachment nuts are below top surface of glass adjustment brackets.
3. Close sunroof to center glass panel in roof opening.
4. Tighten center screws to hold adjustment.
5. Open glass to vent position and complete tightening of attaching nuts; torque nuts to (8 Nm).
6. Close glass, check glass height vertical adjustment and correct as required.
7. Install the mechanism covers by sliding lower portion into slot of aluminum guide. During this step, slide rear of lower portion of cover under drain channel.
8. Extend upper part on the mechanism cover to side adjustment bracket and while keeping cover as far rearward as possible, push it against glass adjustment bracket and at same time slide cover forward to lock in position.
9. Complete installation reverse of removal procedure and adjust wind deflector as described.