Air Bag: Service and Repair

Warning: Before attempting to diagnose, remove or install any airbag system components, unless otherwise noted, you must first disconnect and isolate battery ground cable. Failure to do so could result in accidental deployment and possible personal injury.

Warning: If replacing a deployed module, wear gloves and eye protection. There will be deposits on and around the airbag that could cause skin and eye irritation. If material does come into contact with the body, flush with plenty of cold water.

Fig. 89 Removing Clockspring From Steering Column. W/Steering Column:

Fig. 91 Removing Clockspring From Steering Column. W/Acustar Steering Column:

Procedure

Note: Refer to Airbag Module Disposal under Maintenance for proper disposal procedure of a deployed airbag.

1. Disconnect and isolate battery ground cable.
2. Using a 10 mm thin wall, remove four holding airbag module in place on steering wheel.
3. Lift module high enough to remove clockspring connecting wire and remove airbag module.
4. If replacing a deployed module, clockspring must also be replaced. Refer to Clockspring.
5. Reverse procedure to install and torque nuts to 80-100 in lb.
6. Do not connect battery ground cable. Refer to DIAGNOSIS & Testing for proper procedure.