Cruise Control Servo: Service and Repair

1. Remove speed control cable and mounting bracket to servo attaching nuts.
2. Remove screws attaching servo mounting bracket, then servo mounting bracket.
3. Disconnect vacuum and electrical connector.
4. Pull cable away from servo to expose retaining clip, then remove clip attaching cable and servo.
5. To install, place throttle in wide open position, align hole in speed control cable sleeve with hole in servo pin, then install retaining clip.
6. Reconnect vacuum hose and electrical connector.
7. Install mounting bracket and attaching screws, torque attaching screws to 105 inch lbs.
8. Install servo and servo attaching nuts, torque nuts to 60 inch lbs.